________________________________________

Test Pump and Nozzle

Enables testing of the water pump and abrasive feed

 

Use the Test button to verify that the ProtoMAX pump and nozzle are working correctly. This test is typically used to flush the plumbing lines following maintenance, after clearing a plugged nozzle, or at the start of the day to verify proper operation.

 

Test Cutting Head (Pump, Jet, and Abrasive)
A full nozzle test with high-water and abrasive flow. Activates the cutting head for 60 seconds.

Flush Plumbing
Performs a 30-minute sequence of turning the pump on and off to flush the plumbing. The nozzle, mixing tube, and final filter must be removed prior to doing this test.

Reset Pump
Runs a 30-second sequence to reset the pump. This should be done after changing the nozzle orifice, repairing or replacing the pump, repairing any high pressure plumbing leaks, and over-torque and pressure deviation faults.

Next button
Click Next to open the Test Operations window, providing the Start Test button.

 

Start Test
Click the Start Test button to initiate nozzle testing:

 

 

Close
Click Close to exit the Test operation.